Ford Focus Forum, Ford Focus ST Forum - View Single Post - Engine Pulling
Thread: Engine Pulling
View Single Post
Old 06-28-2012, 10:50 PM   #1
grizz59
Focus Rookie
 
Join Date: Jun 2012
Fan#: 99948
Location: Revelstoke, Canada
What I Drive: 2001 blue se sedan

Posts: 7
FF Reputation: 1 grizz59 Good Standing Member
Buy-Sell-Trade Rating: (0)
Engine Pulling

I am just about to finish pulling the engine block (2L SOHC) out of my 2001 SE. Just wanted to know if the fly wheel-torque converter bolts are undone thru the hole left after starter is taken out.I can see bolts thru starter hole but not sure how to get at them as the are slightly lower than the hole. Any advice would be appreciated.FYI head is already off the block. Was also wondering if cylinder compression ratings of 160-166 are good or bad ratings.

Thanks Colin


grizz59 is offline  
    Reply With Quote