Focus Fanatics - View Single Post - HOW TO: Install VF-Engineering P/S Mount
View Single Post
Old 06-21-2012, 07:17 PM   #15
Buickboy
br/o/stang
 
Buickboy's Avatar
 
Join Date: Oct 2005
Fan#: 28542
Location: Stratford, CT
What I Drive: 72 Skylark, '12 Mustang

Posts: 5,247
FF Reputation: 39 Buickboy Great Standing Member
Buy-Sell-Trade Rating: (29)
Quote:
Originally Posted by SVTF 03 View Post
Over the weekend I installed the poly bushings into the stock lower trans dogbone. Little vibration....an I mean little. Far better shifting and more solid feel.

Just installed the VF Upper Driver and Passenger side poly mounts today. Wow, tons of vibration. Change rattles in cup holder and ash tray and other things in other places. It's not too bad at speed. But at idle and a little above it's a little much. I read all the reviews and all mostly said to stay with the dogbone only for street use and to only use all 3 mounts for racing, etc. I can attest to this. I'm going to run the mounts for now. I'm hoping they loosen up a little. I'm also going to try re-aligning the mounts to see if that will lessen the vibration. Otherwise, if you are really hardcore about getting all your power to the ground....then run these.
i had all 3 and ditched the passenger side one for those reasons. car was every bit as good with the dogbone and upper trans, but nowhere near the vibrations of all 3
__________________
==2012 Kona Blue Mustang V6==
==1995 Light Iris Neon Coupe==
==1972 Skylark==
Buickboy is offline  
    Reply With Quote