Focus Fanatics - View Single Post - The TICK build thread
View Single Post
Old 06-10-2012, 04:05 PM   #16
Magus2727
Focus Fanatic
 
Magus2727's Avatar
 
Join Date: Feb 2009
Fan#: 62897
Location: Salt Lake City, UT
What I Drive: 2001 Malibu Blue ZX3

Posts: 3,938
FF Reputation: 9 Magus2727 Good Standing Member
Buy-Sell-Trade Rating: (2)
Well made some progress this weekend. Got some sensors installed on the block, got the second freeze plug installed, have the rear main seal on. I also worked on the SVT exhaust Manifold and cut off the tabs for the heat shield and ground them down.



The big hole is from removing this pipe...



Trust an exhaust shop to weld in a pipe for an EGR and have it stick in the exhaust runner 1" and be a huge obstruction. I am going to get a piece of 1/8" stainless steel stock bar and heat it up cherry red and bend it to a nice little patch. Then take it to a weld shop who knows what there doing put a patch on and then put on a EGR bung taken from a stock manifold. Like the picture I found below...

__________________
2001 ZX3 2.0L Zetec-
Hatch Nation #42

Going through Rebuild See "The TICK Build Thread" for details (http://www.focusfanatics.com/forum/showthread.php?t=289168&referrerid=62897)
Magus2727 is offline  
    Reply With Quote