Focus Fanatics - View Single Post - Bung size for an EGR weld-on a SVT header?
View Single Post
Old 06-07-2012, 09:14 AM   #2
Focus Fanatic
Magus2727's Avatar
Join Date: Feb 2009
Fan#: 62897
Location: Salt Lake City, UT
What I Drive: 2001 Malibu Blue ZX3

Posts: 4,004
FF Reputation: 9 Magus2727 Good Standing Member
Buy-Sell-Trade Rating: (2)
Should I just get a standard O2 bung that's a 18mm x 1.5mm... and then worry about threading sizes later? If its different?

Has no one else put a fitting on the SVT header to accommodate the EGR? If not a bung, then what,... if at all?

Would like to order this so I can get it welded on sometime next week.
2001 ZX3 2.0L Zetec-
Hatch Nation #42

Going through Rebuild See "The TICK Build Thread" for details (
Magus2727 is offline  
    Reply With Quote