Focus Fanatics - View Single Post - IROC turbo build continues
View Single Post
Old 05-31-2012, 10:10 PM   #1
hardSVT
Turbo Freak
 
hardSVT's Avatar
 
Join Date: Feb 2008
Fan#: 53566
Location: San Diego, CA
What I Drive: 03 svtf

Posts: 2,187
FF Reputation: 5 hardSVT Good Standing Member
Buy-Sell-Trade Rating: (7)
IROC turbo build continues


So I some of you guys know I purchased Roccos zx3 . It was a great deal and I'm very excited to say that I am the new owner. I will be heading to FSwerks tomorrow to begin tuning on the dyno.

This is what is done to the motor
Low Mileage Zetec Block. Bored/Honed with deck plate .007 over.
Stock Crank , oil holes chamfered, polished journals
Eagle connecting rods. JE 9.0 -1 pistons.
Comp cams stage II`s.
Ford racing headd
75mm Roush Racing throttle Body. Kenne Bell BAP . New SVT fuel Pump. And the 60lbs injectors.
ARP main and head studs. AEM cam gears.
Fidanza Flywheel, Competition Clutch stage 4 clutch.
Tial 50mm BOV and Tial 44mm WG.
New 2.5" hot side and 3" cold side to tb aluminum pipe.
Low mileage MTX with Torsen installed.

Things I have done already

Euro grille

Euro star LEDs

Red and black Svt interior swap


Svt coolant degas cover
Svt side mirrors that I vinyl wrapped
myself


Svt black carpet kit swapped
Svt center console swapped
Svt speaker swapped
Things to do

Svt bumpers and side skirts/ paint /car have them

H&R coilovers already have them just need to install

Fswerks rear stress bar

Mach headlight install

New trans with hopefully a one off throw out bearing that won't break!

Swap slotted rotors

Fswerks dyno

http://www.youtube.com/watch?v=T8OyW...e_gdata_player


__________________
RIP SVT
300hp mazdaspeed3
Rocco's built turbo zetec mine now!

Last edited by hardSVT; 06-02-2012 at 01:50 PM.
hardSVT is offline  
    Reply With Quote