Ford Focus Forum, Ford Focus ST Forum - View Single Post - M-3000-ZX3 kit questions
View Single Post
Old 04-28-2012, 09:37 AM   #25
KevinM
Focus Rookie
 
Join Date: Apr 2012
Fan#: 98309
Location: San Diego, CA
What I Drive: 2003 ZX5

Posts: 2
FF Reputation: 3 KevinM Good Standing Member
Buy-Sell-Trade Rating: (0)
Make sure you install the new rear springs properly. The springs have a plastic cover on part of the coil, which should be up top. I installed the kit on my car a couple weeks ago and did each side differently because I wasn't paying attention. With the plastic cover on the bottom of the spring it made all kinds of noise and I had to take it all apart again and flip the spring over.
KevinM is offline  
    Reply With Quote