Just started working on this -
the fuel pump access tutorial I found on this forum is below
I went to the junkyard first to make sure they had a donor focus. I drilled holes in the corners of the square of metal over the fuel pump and used a hammer and screwdriver to cut the metal - no problem cutting hoses etc. - though very very slow and arduous going. While I was there i pulled the fuel pump out too! (can't hurt to have a spare, right?).
However, the sock looks pretty dirty. I'd like to know if you have any recommendations for where to get a new one specifically?
The one you posted does not look like the same part (different bag shape) - does this matter?