Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Replaced rear 02, still throwing CEL codes?
View Single Post
Old 04-17-2012, 04:22 PM   #3
mikebontoft
Aurelius Pardus
 
mikebontoft's Avatar
 
Join Date: Aug 2008
Fan#: 58647
Location: SLC, UT
What I Drive: 5.9L Grand Cherokee ZJ

Posts: 26,266
Points 23,515, Level 94
Points: 23,515, Level: 94 Points: 23,515, Level: 94 Points: 23,515, Level: 94
Level Up 17% Completed
Level up: 17% Level up: 17% Level up: 17%
Forum Activity 17%
Activity: 17% Activity: 17% Activity: 17%
FF Reputation: 76 mikebontoft Excellent Standing Member
Buy-Sell-Trade Rating: (3)
if they are all running on the same circuit (Don't have a diagram handy) you may have a wire or sensor shorting to ground. These circuits use a current limiter so the wires will not burn up.... the problem with that is the part in the circuit that is bad will use all of the amperage and all of the GOOD sensors will throw codes. You need to take a look at that. I may grab a diagram in a minute here... I like these kind of problems.
__________________
SR #127 | '02 Focus SE "Foci" (5.0 RWD - parted) | '75 BMW 2002 "Carby" (racecar) | '98 Jeep Grand Cherokee 5.9L (lifted and fast) | '99 BMW 328is (daily).
ModeratingGeneral Chat Lounge, General Technical Chat, Ford Focus & General Car Chat, and Rocky Mountain Fanatics
mikebontoft is online now  
    Reply With Quote