Focus Fanatics - View Single Post - M-3000-ZX3 kit questions
View Single Post
Old 04-12-2012, 06:14 PM   #3
sailor
"Elder"
 
sailor's Avatar
 
Join Date: Jun 2008
Fan#: 57268
Location: Williamsville, NY
What I Drive: 2004 Pitch Black ZTS 2.3 5spd.

Posts: 11,337
FF Reputation: 60 sailor Excellent Standing Member
Buy-Sell-Trade Rating: (0)
I used the M-3000-ZX3A kit from Tousley, that one comes with pre-assembled front struts so I didn't need the mounts & bearings that you will need. It also did NOT come with a rear SVT bar, so I'm still using the stock one.

You should use new sway bar bushings to fit the new bar, being a ZTS you SHOULD have a rear bar already...

Interesting that you have a PZEV 2.3 in Michigan, since that isn't a "California" state or next door to one, unless you count across Canada to N.Y. as being next door...

My Lower arm bolts were frozen at lower mileage, left them alone for now as the bushings weren't sacked yet when I installed the kit.

Agree with Geezer that you could use them, plan on new bolts as you'll be cutting them most likely....

I broke a sway bar link not too long after the kit went in, since you have to get one end loose anyways for the install it WOULD be a good time for replacement....

Luck!
sailor is offline  
    Reply With Quote