I did a brief test this morning. I have the top of my mic completely sealed off with a piece of half inch compressed foam. Practically the same kind that earplugs are made out of. :) I checked it yesterday and I cut it just perfectly to where its wedged in and not even daylight can reach the mic from the top side.
This morning I did a test and when I put my palm over the mic the play back was absolutely SILENT. So the noise is coming from the over amp'd Mic in the overhead. Its not picking up squat from the backside.
Does anyone know if I could turn down the volume on my Bluetooth Volume via my Iphone would that lower the sensitivity of the mic? If it is in fact the phones fault that someone mentioned maybe this would explain it.
If not I will try to figure a way to maybe lessen the sensitivity of the mic somehow.