Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - Basic Bolt-ons: Intakes and Induction
View Single Post
Old 11-30-2011, 12:46 PM   #207
sketchman
Focus Enthusiast
 
Join Date: Nov 2011
Fan#: 92116
Location: Verner, WV
What I Drive: 1988 Mazda 323 GT - .42/.48 T3 :)

Posts: 80
Points 666, Level 13
Points: 666, Level: 13 Points: 666, Level: 13 Points: 666, Level: 13
Level Up 32% Completed
Level up: 32% Level up: 32% Level up: 32%
Forum Activity 0%
Activity: 0% Activity: 0% Activity: 0%
FF Reputation: 1 sketchman Good Standing Member
Buy-Sell-Trade Rating: (1)
Quote:
Originally Posted by ProudFordFanatic View Post
The one i just ordered was this one.

http://fswerks.com/fswerks_coolflo_air_intake.htm

It will fit right? I did good?
K&N make a similar one that has a uniform 2.5" size from filter to throttle body that I personally chose over the fswerks one. It's also aluminum, so it'll never rust.

Don't understand why the neck down into the MAF part and then back up to the size for the throttle body makes any sense. K&N also make a plastic one that has the neck up and down for the MAF location but the transitions are smoother and I would also choose it over the fswerks one.

Metal One:
http://www.knfilters.com/search/prod...Prod=69-3512TP

Plastic One:
http://www.knfilters.com/search/prod...x?Prod=57-2559
__________________
Any difference that makes no difference is no difference.

Lemme splain. No, is too much. Lemme sum up. The flow no know where I go.

Last edited by sketchman; 12-30-2011 at 07:54 AM.
sketchman is offline  
    Reply With Quote