Focus Fanatics - View Single Post - Replace master cylinder clutch
View Single Post
Old 11-26-2011, 06:43 PM   #66
redfoxglove
Focus Rookie
 
Join Date: Nov 2011
Fan#: 92133
Location: Hoquiam, WA
What I Drive: 02 ZX5 hatch Toreador red

Posts: 4
FF Reputation: 1 redfoxglove Good Standing Member
Buy-Sell-Trade Rating: (0)
thanksabuncha

Wow guys, thanks for all the comments and support. Those pics are awesome. Hope you can get it into the archive.

Husband finished the job today, I think it took him about 6 hours total. But 2 of those hours were trying to figure out how to get those clips off. With the info I gave him from this site, it was just minutes later he had them off. He didn't fold back the wheel well cover but thought about it. Managed to do it without.

Just a comment, the Ford dealer wanted $127 for the part and a 3 day wait. But CarQuest had it in stock for $65.

My car has 93K on it. Had to have the power steering sensor and pump done about 500 miles ago. Also replaced the front right axle at about 80K.

I'll be reading on this site for more ideas. I might want to tune it up a little, make it go faster?

Thanks again.
redfoxglove is offline  
    Reply With Quote