When i take the wideband 02 out of the last bung should i plug it? or put the stock 02 back in?
I read in the innovate manual that its not good to run the sensor in the pipe if its not hooked up. Somthing about the heater needs to be hooked up and heating or it would ruin the sensor. Not sure if the stock ones are like this or not?
Right now Tom has the last sensor turned off, but does that mean its just not sending data? or not heating either?
Ill need to plug the hole either with the stock sensor or a plug.
DX3?.. huh?.. well ZX3 = Zetec the 05-07 has a Duratec so D