Focus Fanatics - View Single Post - knock sensor issues
View Single Post
Old 04-25-2011, 03:56 PM   #19
EggYolkedZX3
Focus Enthusiast
 
EggYolkedZX3's Avatar
 
Join Date: Jan 2009
Fan#: 61654
Location: Henderson, NV
What I Drive: '01 Yellow ZX3, '04 Blue SVT w/EAP

Posts: 126
FF Reputation: 8 EggYolkedZX3 Good Standing Member
Buy-Sell-Trade Rating: (3)
Quote:
Originally Posted by 1turbofocus View Post
The KS should not of shown knock if it was not bolted on , You removed the sensor just below intake runner 2 in the block on a stud that kinda looked like a doughnut with wires ?

Tom
Yes sir, that's the one and it showed knock in the datalog even though it was not bolted to anything.

Quote:
Originally Posted by redZX300 View Post
The reason I said the KS would or could show knock if not attached to the block would be it was rattling on something, but I guess if he wrapped it up in paper towels that could keep it secure enough.

But that's odd it would still show knock, maybe an electrical connection?
Yea that's what my dad and I were thinking next. I'll do a continuity test next time I get a chance and confirm the wiring is good. It does run in a harness that goes in between the 1 and 2 intake runners where it could of chafed on the rough edges of '01 and up intake manifolds. As far as I can see though, it looks fine.

Thanks for the help so far guys.
EggYolkedZX3 is offline  
    Reply With Quote