Focus Fanatics - View Single Post - HOW TO-Make custom inserts for door panels
View Single Post
Old 04-24-2011, 11:35 AM   #11
miragesmack
Focus Addict
 
Join Date: May 2009
Fan#: 65159
Location: Louisville, KY
What I Drive: 2000 Sony Edition Sedan

Posts: 1,177
FF Reputation: 3 miragesmack Good Standing Member
Buy-Sell-Trade Rating: (9)
I have the same problem Dirt. FYI, those plastic tabs make it a lot harder to get the inserts off, since they go through the insert. Drill them out. My plastic strips were gone, but I did find some replacements. Once they are off, they won't go back on with mechanical means, since you have to break them off. I was trying to save any pieces of the tabs if possible, but then you have to drill a hole through your new inserts, so eff that.

These are standard in Europe, and I see a lot of folks over there just gluing them back on once they re-do their inserts. This gives you a little flexibility, you can test fit them to see if they look good. I plan to drill out the old peg mounts to remove the insert, recover the inserts, then glue my strips on later.
miragesmack is offline  
    Reply With Quote