Focus Fanatics - View Single Post - HOW TO-Make custom inserts for door panels
View Single Post
Old 03-16-2011, 06:17 PM   #38
Davey Boy
Focus Enthusiast
 
Davey Boy's Avatar
 
Join Date: Aug 2010
Fan#: 78161
Location: Morrison, CO
What I Drive: 03 Black SVT

Posts: 306
FF Reputation: 5 Davey Boy Good Standing Member
Buy-Sell-Trade Rating: (0)
None on the face side, I didn't use anything on the face side to hold the suede down, but I think a small amout of spray adhesive would have been smart to prevent wrinkles, long as you test it first to make sure it doesn't bleed through or cause discolouration. I used ended up buying way more than I needed and it was still only $8. I can't really remember but just lay all the inserts out on a sheet and leave like 6 " between each piece and the edge of the sheet to figure out how much square footage you need.
Davey Boy is offline  
    Reply With Quote