Focus Fanatics - View Single Post - Gear Concept Shifter Bezel
View Single Post
Old 11-10-2003, 11:43 PM   #18
Jake
Focus Enthusiast
 
Jake's Avatar
 
Join Date: Sep 2003
Fan#: 535
Location: Washington State
What I Drive: MMIII ZTW, 5 spd.

Posts: 325
FF Reputation: 1 Jake Good Standing Member
Buy-Sell-Trade Rating: (0)
Sorry my pic dosen't show the allen head bolts. You can prob imagine what they look like. They are stainless steel and look classy. If you find some they are easy enough to install.
Simply unscrew you bezel, and drill straight through. You'll need to remove the boot, which just pops right out. PUt the Bezel back on, drop the bolt through, and attach the nuts. It takes some patients to get the nuts started and you'll need a pretty small wrench to hold them untill they firm up, but it's not that hard. The whole install takes about 45 min.
If I think about it I'll use my real camera (that photo was taken with a shoot and toss) and take a close up.
__________________
Oh, people can come up with statistics to prove anything, Kent. 14% of people know that.

-Homer Simpson

Last edited by Jake; 11-11-2003 at 02:38 AM.
Jake is offline  
    Reply With Quote