Originally Posted by SMITHBOY76908
Very nice progress!!!
Thanks! Progress has been slow because all the prep but nice.
Originally Posted by 1turbofocus
Looks to be down a little far ? I would wald some small pieces on Alum on the top side of the intake so the washers had something to hold with , some one local shouldnt charge more then about 30.00 if you cannot do this your self. The intake is thick enough that it doesnt warp and just hitting it with a file always seemed to get it all flat
Glad I could help
That's what I meant with no space to slot, to make sure did a template to match the runners and the amount to slot, instead of the custom gasket for it, went with the o-rings, it will be the correct way but would not touch it anymore, the bottom ones keeps it in height and all of the top ones had some material under the bolts, added washers just in case. Thanks again.