Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - removal of crankshaft pulley bolt?
View Single Post
Old 05-05-2010, 09:06 AM   #76
the_doc735
Focus Enthusiast
 
Join Date: Apr 2010
Fan#: 74469
Location: hull, United Kingdom
What I Drive: focus lx blue

Posts: 147
FF Reputation: 1 the_doc735 Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by a_2000_se View Post
-
Ok - how about locking up the piston in the cylinder, head still installed?:

- I read, someone here uses thin rope inserted into the spark plug hole

OR -

- Again on the compression stroke, fill the cylinder with motor oil. I haven't figured out what the conversion is for 'PSI to ft-lbs' in a 1.6 liter engine. Don't exceed the rated compression of your cylinder. You might get a little smoke when you start it up - again, depending on how long you let the oil drain past the rings?

It doesn't appear you are in a hurry?

This is fun......
the rope and the oil are worthy of consideration, thanks for that one! Let's just say I can't afford to rush or hurry this process; I'm not "throwing caution to the wind" ~ LOL.

This is fun? ~ this made me laugh, thanks for injecting a little humour into this scenario LOL.
the_doc735 is offline  
    Reply With Quote