Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - removal of crankshaft pulley bolt?
View Single Post
Old 04-30-2010, 10:24 AM   #41
the_doc735
Focus Enthusiast
 
Join Date: Apr 2010
Fan#: 74469
Location: hull, United Kingdom
What I Drive: focus lx blue

Posts: 147
FF Reputation: 1 the_doc735 Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by Grumpy View Post
The single lug/tooth design tool should hopefully do the job for you, but you would hate to snap off a gear tooth or break the tool, considering that your's seems to be really tight. The two or three lug/tooth design tool will just distribute the load over more teeth. I've seen both designs.......surely you can locate/buy/rent one at your location in Britain.
the only multi tooth tools I can find in the UK are for things like: peugeot, citron, renault, rover/MG etc. But not the ford zetec se 1.6 petrol engine, even that Sealey (single tooth) Ford Engine Flywheel Locking Tool Set - Model No: VS4834 is only for the 1.6 Ti-VCT Petrol Engine and non of the shops I have contacted in the UK can say if it is suitable for the 1.6. Zetec SE engine???
the_doc735 is offline  
    Reply With Quote