Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - removal of crankshaft pulley bolt?
View Single Post
Old 04-29-2010, 07:07 PM   #40
Grumpy
Focus Addict
 
Join Date: Feb 2007
Fan#: 43791
Location: Vancouver, B.C.
What I Drive: 2005 Sonic Blue ZX3

Posts: 868
FF Reputation: 28 Grumpy Great Standing Member
Buy-Sell-Trade Rating: (0)
The single lug/tooth design tool should hopefully do the job for you, but you would hate to snap off a gear tooth or break the tool, considering that your's seems to be really tight. The two or three lug/tooth design tool will just distribute the load over more teeth. I've seen both designs.......surely you can locate/buy/rent one at your location in Britain.
Grumpy is offline  
    Reply With Quote