Ford Focus Forum, Ford Focus ST Forum - View Single Post - removal of crankshaft pulley bolt?
View Single Post
Old 04-29-2010, 01:51 PM   #31
the_doc735
Focus Enthusiast
 
Join Date: Apr 2010
Fan#: 74469
Location: hull, United Kingdom
What I Drive: focus lx blue

Posts: 147
FF Reputation: 1 the_doc735 Good Standing Member
Buy-Sell-Trade Rating: (0)
Quote:
Originally Posted by Missourileo View Post
Keep in mind, if the air compressor that you are using only puts out, let's say 60 psi, then you aren't getting the full potential of the impact. It doesn't matter if you have a 50,000 ft. pound impact, if there is not sufficient air.......it's useless. You can put a breaker bar,short extension combo on the bolt, lower the car on the breaker bar and it will break it loose. Do this slowly with a jack.
thanks! ...yes I realise that but nice of you to point it out just in case I didn't know
the_doc735 is offline  
    Reply With Quote