Originally Posted by zetec00
It will be a blow thru MAF setup. My charge piping is 2.5" and I was wondering, would be better to weld the maf flange onto the 2.5" charge piping or could I use a 3" housing?
You can weld a slot type flange and use the slot MAF right in the piping or you can get a 3 inch MAF tube and use the stock MAF in the 3 inch tube or the slot in the 3 inch tube
There are 3 inch slot tubes out there because I just sent out 2 shipments of 450 of them to 2 places , I am not allowed to say who they went to but you can buy them if you look around