Ford Focus Forum, Ford Focus ST Forum - View Single Post - LED Interior Mod question
View Single Post
Old 09-26-2004, 08:20 PM   #3
ouikikazz
Focus Fanatic
 
Join Date: Apr 2004
Fan#: 6707
Location: Staten Island, NY
What I Drive: 2k2 Infra-Red SVT Focus

Posts: 1,711
FF Reputation: 1 ouikikazz Good Standing Member
Buy-Sell-Trade Rating: (9)
Quote:
Originally posted by bak9799
you do not need resistors as long as your replacing LED's with LED's
but if your replacing bulb with LED's then you need to put a resistor in-line (470 ohm if your using a 3.4 volt LED)
Hope this helps
which are bulbs which are LEDs? Any specifics i should be cautious of before doing the whole conversion
ouikikazz is offline  
    Reply With Quote