Ford Focus Forum, Ford Focus ST Forum - View Single Post - LED Interior Mod question
View Single Post
Old 09-26-2004, 07:28 PM   #2
bak9799
Focus Enthusiast
 
bak9799's Avatar
 
Join Date: Dec 2003
Fan#: 2170
Location: Pittsburgh, PA
What I Drive: 2000 Focus ZX3, Pitch Black

Posts: 219
FF Reputation: 1 bak9799 Good Standing Member
Buy-Sell-Trade Rating: (0)
you do not need resistors as long as your replacing LED's with LED's
but if your replacing bulb with LED's then you need to put a resistor in-line (470 ohm if your using a 3.4 volt LED)
Hope this helps
bak9799 is offline  
    Reply With Quote