Focus Fanatics - View Single Post - Need good wheel studs/lugs
View Single Post
Old 07-23-2007, 10:02 PM   #6
goinloco1
Late for Dinner
 
goinloco1's Avatar
 
Join Date: May 2004
Fan#: 8529
Location: Aberdeen, SD
What I Drive: 13 stang

Posts: 15,189
FF Reputation: 90 goinloco1 Excellent Standing Member
Buy-Sell-Trade Rating: (2)
Quote:
Originally Posted by macdiesel View Post
goinloco1, would you recommend the kyokugen lug nuts with stock studs? If not how difficult was the arp stud install?
wouldn't recommend the stock studs for any type of racing period. once you get the arp studs and whichever open end nuts you prefer, replace a lugnut with a new one, hand tight is fine, you'll see what i mean about thread engagement. and its worse with some aftermarket wheels that have a thick hub flange.

studs are actually not hard to replace , i did all of mine on the svt with just the wheels off. make sure you have a stack of washers or an oversize nut, then use an old lug nut to pull the stud in when you tighten it.

i'd also recommend checking the tightness several times, about every 25-50 miles, to make sure they fully seat. and torque them, don't just crank them down
goinloco1 is offline  
    Reply With Quote