Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum - View Single Post - PRODUCT FAQ: Duratec / Zetec / SPI Lower Engine Torque Mount
View Single Post
Old 08-29-2006, 10:49 PM   #4
scyzzo17
Focus Enthusiast
 
Join Date: May 2004
Fan#: 8025
Location: Orlando, FL
What I Drive: 2002 Focus ZX3

Posts: 81
FF Reputation: 1 scyzzo17 Good Standing Member
Buy-Sell-Trade Rating: (1)
i don't have a digital camera but i'll try to explain. The end of the mount that connects to the transmission. It will not fit. I took off the bracket, it had three bolts two parallel and one perpendicular. The bolt goes through the bracket then the mount then the threaded side of the bracket. On the unthreaded side of the bracket there's a cyclinder in a hole in the bracket. The cyclinder has a hole in it for the bolt to go thrrought. THAT cyclinder is pushed in and wedge at an angle so I cannot move it. I'm not sure what its called but I want to say it a bushing.


This is a zetec by the way.
scyzzo17 is offline  
    Reply With Quote