Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   MK1 Focus (http://www.focusfanatics.com/forum/forumdisplay.php?f=45)
-   -   Side Moulding Removal (http://www.focusfanatics.com/forum/showthread.php?t=317762)

homey55 05-30-2013 08:59 AM

Side Moulding Removal
 
How do you remove it? Is it just taped on or are there clips too? Searched the whole section and couldn't find it. I need to remove the side moulding to apply wrap and re-install them.

nov173 05-30-2013 09:24 AM

I had 2000 focus which just had tape and small rods that slid through i think 3 holds along the panel. I had no clips. Just used a heat gun and worked my way down with some fine string to cut through the tape.

Buickboy 05-30-2013 01:35 PM

early cars usually had clips, laters are just stuck on. my 2001 had clips.

You can see the clips if you pull the door panel and look from the inside.

stealthzx3 06-02-2013 11:50 PM

Mines an '01 and is only held on by the tape, so no clips. Just take a flathead and pry an end out and pull.

204ZX3 05-20-2014 10:08 PM

I know this is a year old, figured I'd bump it rather than make a new thread.

Re applying them, just 3m double sided auto tape? Or is there a glue I should use.

Sniper Focus 05-21-2014 01:07 AM

3M tape was all that was holding mine on.

tgowers 05-21-2014 09:04 AM

The best way to loosen the adhesive tape is with WD40. Soak it down really good and it should come off much easier.


All times are GMT -5. The time now is 07:38 AM.


http://www.focusfanatics.com/aboutus/copyright.asp