Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   SPI Performance (2000-2004) (http://www.focusfanatics.com/forum/forumdisplay.php?f=42)
-   -   need advice/member of droped valve seat (http://www.focusfanatics.com/forum/showthread.php?t=316162)

Lannie 05-09-2013 04:28 PM

need advice/member of droped valve seat
 
2003 se focus. replaced piston number 3, rod and rings. New head and gaskets, cleaned out egr and intake. Car has been running about 2 weeks. Started having problems starting. It will start out slow then catch up and start and run fine. 3 days ago it died at stop sign. Got it started and home. Noticed coolant was low. Added some, then check compression. Pulled valve cover off and discovered i have coolant in the oil. Used haynes manual to tear down and rebuild. any ideas

p58ff 05-30-2013 07:51 PM

My first guess would be a head gasket not sealing. Any white exhaust smoke?

ImBillT 05-31-2013 01:35 PM

From Toyota forums I have picked up that only factory and fel-pro head gaskets can be trusted, and even then the Fel-pro head gaskets were getting mixed reviews. Most people there had problems with erisitic gaskets, domestic gaskets, and a few I don't remember. They said the rest of the gasket kits were fine, just not the head gaskets. I assume you used new head bolts, ran a tap into the bolt holes in the block, cleaned the holes, LIGHTLY oiled the bolt, and used a head which had been properly checked or remachined.


All times are GMT -5. The time now is 10:05 PM.


http://www.focusfanatics.com/aboutus/copyright.asp