Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   General Forced Induction (http://www.focusfanatics.com/forum/forumdisplay.php?f=44)
-   -   water cooling turbo? (http://www.focusfanatics.com/forum/showthread.php?t=311123)

svtf1417 03-07-2013 01:56 PM

water cooling turbo?
 
First of all, I would like say either I can't do one of the simplest tasks, or I've found a question google searches and focus fanatics searches can't answer.

That being said, has anyone tapped into their water lines to cool their turbo? I have a ball bearing turbo and didn't cool it at all last year and never had problems considering I have a pump to pull all the oil out of the turbo when I shut the car off so it doesn't cook.

I have a good idea of where I can tap into for the feed line, but I don't really know where I should drain it too since the turbo sits so low. Any insight whether how to do it or if it's even worth my time would be greatly appreciated

Deftmetal 03-07-2013 04:10 PM

OEM turbos are the most common to use coolant and oil from the engine.

I'm not sure where you could drain to but it's such a small line it might be fine to run it up to the coolant reservoir. I'm not very familiar with the engine but there must be an easy spot to tap a hole close to the pump or along the pressurized side of the system

paulg127 03-09-2013 12:44 AM

I tried to tap lines that had some distance or hardware between the tap points to provide some flow (pressure differential) through the turbo. The 'turbo by garrett' site provided some good insight to the ideal angle the fittings shoule be at to provide maximum thermo siphon effect. http://www.turbobygarrett.com/turbob...il_water_lines

Of course with a bearing turbo, you probably don't need the H2O cooling...my e-bay crapper turdbo needs all the help it can get...

I'm on Hanford, you can swing by to check out the tap points.

NJSVTGUY 03-09-2013 07:32 AM

The coolent doesn't gravity drain from the turbo. The retun line does not have to be lower. That's how a stock GN is routed.... the return runs higher. Another option is to use an air cooled PTE turbo, that's what I run.

PSUrivie 03-09-2013 10:39 PM

This is a great read for water cooling.

http://www.turbobygarrett.com/turbob...er_Cooling.pdf

beansfocus 03-10-2013 04:53 PM

For my gt28r on my 09 I spliced into my heater core hose to feed the turbo with coolant

svtf1417 03-10-2013 06:33 PM

all great info thanks guys. Paulg I just might have to do that at some point!

Quote:

Originally Posted by beansfocus (Post 4629659)
For my gt28r on my 09 I spliced into my heater core hose to feed the turbo with coolant

Where did you run the return line to?

beansfocus 03-10-2013 06:52 PM

Idk how your turbo is setup but on my Garrett the turbo has an inlet and outlet for the coolant so I cut the heater hose going from the motor to the core and have it enter the turbo and then exit the turbo

ZXthrizzle05 03-10-2013 07:09 PM

id recommend like earlier posted an air cooled PTE


All times are GMT -5. The time now is 05:45 PM.


http://www.focusfanatics.com/aboutus/copyright.asp