Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum

Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum (http://www.focusfanatics.com/forum/index.php)
-   ZETEC Performance (2000-2004) (http://www.focusfanatics.com/forum/forumdisplay.php?f=39)
-   -   Help - Extra Hole in My Head (http://www.focusfanatics.com/forum/showthread.php?t=310116)

sdaddy 02-24-2013 06:31 PM

Help - Extra Hole in My Head
 
I'm installing a performance head on my Zetec Blacktop. In working on the cam timing, etc. (see additional posts) I found an "extra" hole on the intake side. Some internet research leads to the conclusion that is an oil galley hole and the size is 1/8" NPT. I bought 1/8" NPT plugs and they don't fit. I also took the two plugs from the back of the head to see if they would fit.... no luck.

Any ideas on what the hole pictured below is is and what I should do? [dunno]

Thanks [pray]

https://lh6.googleusercontent.com/-B...0/DSCN7201.jpg

iminhell 02-24-2013 11:26 PM

Should see if the CHT Sensor fits ...

6SPD_soul 02-25-2013 10:13 AM

Quote:

Originally Posted by iminhell (Post 4606866)
Should see if the CHT Sensor fits ...

You might be right, I just looked it up on Alldata and the CHT sensor should be right in that area.

Mustangsix 02-25-2013 07:29 PM

It's for the Water Temp Sender. If you don't need to use it, you can use a 10mm bolt with a washer.

iminhell 02-25-2013 09:06 PM

Quote:

Originally Posted by Mustangsix (Post 4608331)
It's for the Cylinder Head Temp Sender (CHT). If you don't need to use it, you can use a 10mm bolt with a washer.


*fix'd


All times are GMT -5. The time now is 12:28 AM.