Backseat Reinstall on a zx3
 

Hey Folks I need to put my backseat back in and I have all the brackets and bolt etc. just can't remember how it goes back in. I was wondering if anyone had or could take pictures of the brackets so I can figure out how to put it back together



This is on a 2007 zx3

I had to run out to my garage, so I snapped some pics. It's a 2002, so I hope they work for ya!


this one is taken from the perspective of the trunk looking forward:
http://i1269.photobucket.com/albums/...psd2905ec4.jpg


this one is taken from the perspective of the drivers seat looking backward:
http://i1269.photobucket.com/albums/...pse543a7f2.jpg

Thanks for the help! Some additional pictures would be helpful of the brackets on the wall where the backrests latch after you put them back up when you fold them

passenger-side seatback bracket. driver's side is same.


http://i1269.photobucket.com/albums/...psf4e64a52.jpg

Thanks for your help!! I got everything in but I had these two brackets left afterwards I figured out that they were car seat mounts but don't see how they're suppose to bolt in

http://postimage.org/image/42uaqed6b/


help?http://postimage.org/image/42uaqed6b/

there are separate bolt holes, but they are right under the seat backs ie. u need to take the seats out to get them in. The loops would then be positioned exactly in the crack between the seat back and bottom. I would do it, cuz i think water might be able to get in if you dont plug those holes