Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   General Technical Chat (http://www.focusfanatics.com/forum/forumdisplay.php?f=47)
-   -   key wont turn (http://www.focusfanatics.com/forum/showthread.php?t=307334)

finalfantasy 01-23-2013 11:58 AM

key wont turn
 
Just happened on the first very cold morning.

I could not find any posts that had a case of this occurring in extreme cold. Before I try drilling it out, is there any possibility it may be related to the shift interlock system or something else prone to sieze in cold?

Thanks!

Neptune15 01-23-2013 02:06 PM

Did you try jimmying the steering wheel back and forth?

finalfantasy 01-23-2013 02:10 PM

Yes i tried that. I tried graphite, wd40, blow dryer to heat up area (have entire cylinder/collumn area disassembled with PATS removed) soft hammer tapping, etc

ruger 01-23-2013 02:47 PM

this happened to me in the summer. you have to replace the cylinder they wear out over time

whynotthinkwhynot 01-23-2013 05:39 PM

Yes we have a thread on this.

Here's what you do. Go to your local Ford dealer, purchase a new lock cylinder. The new design will not lock up. Take your key and the new lock cylinder to a locksmith. Have them key the new lock cylinder to your key.

Now, it's time to drill out the old lock cylinder. I would usually advise people to at least try to turn the key using some tricks, but you've already tried those.

Drilling out the Lock Cylinder after Lock-up

amc49 01-23-2013 07:16 PM

Definitely not the shift interlock, all that controls is a solenoid that disables the shifter ONLY.

finalfantasy 02-24-2013 12:39 AM

just an update on this, few weeks back i followed the TSB for bore size and location on the cylinder with a cobalt bit and it went through fast and easy. picked the lockbar out with allen keys and swapped in a new cylinder.

i definately second the cobalt over an old pair of drill bits.


All times are GMT -5. The time now is 09:31 AM.


http://www.focusfanatics.com/aboutus/copyright.asp