Hatch Euro tails wiring question I have bulb sockets and pigtail harness
 

1. I have the bulb holders and the harness that goes to the bulbs do I still have to do the wiring deal under the glove box or can I cut off my plug from the US spec tails and wire it up to the Euro tails harness and just leave the Reverse wire un plugged?

I don't want to run a bunch of wire through the hatch I want it as factory as possible, preferably plug and play.

2. Will the hazard switch work correctly after this mod? "only orange flashing out back"

3. Ive found like 5 different how to's???? which is the best one to use

You are still going to have to re-wire your car. Simply adding Euro pigtails will not solve the separate turns. Only way to separate the turns is to re-wire your GCM. Best how-to is this one:

http://www.focusfanatics.com/forum/showthread.php?t=286890

That is how I did mine:)

If you use the how-to I posted, your hazard switch will work correctly as well.

^^^ Thank you Pyro.... running 2 wires all the way back is a bitch...

what about this? I will be soldering no bs scotch locks

http://i122.photobucket.com/albums/o...y/diagram1.gif

http://www.focusfanatics.com/forum/showthread.php?t=172884

Yes, that is another good thread. The diagram you posted is what you need to do for the GEM, you will still have to pull the D/S hatch carpet off to re-wire that also.

cool man thank you and the bulbs in the euro tails look like 1156 for turn and 1157 for running/brakes is this correct