Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   ZETEC Performance (2000-2004) (http://www.focusfanatics.com/forum/forumdisplay.php?f=39)
-   -   SVT intake manifold (http://www.focusfanatics.com/forum/showthread.php?t=306787)

katiekay 01-16-2013 08:17 PM

SVT intake manifold
 
Will the SVT intake manifold bolt on to the Zetec? If it does, would I have to mod it to fit. Will I see any improvement by adding the SVT intake manifold to my Zetec?

Thanks for your help guys[ffrocks]

1turbofocus 01-16-2013 10:12 PM

You will have to slot the bolt holes to get the runners to line up properly , the bolt holes line up just fine
You will need a way to get the intake manifold runner control to open the short runners at just over 5000 rpm
In my opinion no it adds no performance to the Zetec engine

Tom

katiekay 01-16-2013 10:23 PM

Thanks Tom! Just trying to figure out what I can use off this SVT engine:)

1turbofocus 01-17-2013 07:40 AM

The SVT header is about it

Tom

ZXthrizzle05 01-17-2013 09:27 AM

Their mmanifold sux anyway. The only good part is the lower. The upper has little donutgasketsinsidewich can eventually get lodged into the head

iminhell 01-18-2013 08:35 PM

SVT intake manifold will support more power than any other stock manifold.
I never slotted mine and never had a single issue, 4'ish years on the stock head.

If you have it, the swap is worth it because it's free. It's not going to reduce power.


All times are GMT -5. The time now is 05:52 AM.


http://www.focusfanatics.com/aboutus/copyright.asp