Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   Archive (http://www.focusfanatics.com/forum/forumdisplay.php?f=103)
-   -   WTB: AEM intake - throttle body elbow - zetec (http://www.focusfanatics.com/forum/showthread.php?t=306749)

Mile30 01-16-2013 12:49 PM

WTB: AEM intake - throttle body elbow - zetec
 
I disassembled my cold-air intake to group it with a pile of parts due for the powdercoaters on Monday; but the rubber boot/elbow that connects the MAF section of the intake to the throttle body had become fused with the tube...

I asked the metal refinisher people to just cleanly slice the boot and remove it if worst-came-to-worse, so not to damage the tubing; he ended up bending the hell out of the end of the tube using a screwdriver AND ripped some of the rubber from the inside of the boot as he tore it off. Sooooo; now I can't even use the elbow again AND the tube was compromised!!! The chewed-end is facing the camera; YOU SEE IT?!?!
http://i1122.photobucket.com/albums/...ps54d71c18.jpg

I need a new/used-but-safe rubber elbow for the throttle body-to-tube portion! And possibly a new upper intake tube (depending on how the finished job turns out!)!

Here's the part I need:
http://i1122.photobucket.com/albums/...ps1ffce76d.jpg



Can anyone oblige?!

Buickboy 01-16-2013 04:50 PM

I would measure the tube and the TB, go on ebay and look for silicone couplers. I found a 2.5" to 3" 90deg bend elbow for 15 shipped for my project, you can probably find something cheaper depending on sizes


All times are GMT -5. The time now is 03:57 AM.


http://www.focusfanatics.com/aboutus/copyright.asp