Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   General Forced Induction (http://www.focusfanatics.com/forum/forumdisplay.php?f=44)
-   -   FSWerks kit intercooler dimensions (http://www.focusfanatics.com/forum/showthread.php?t=306557)

Fernando_221 01-14-2013 10:27 AM

FSWerks kit intercooler dimensions
 
Hi,

Anyone have the information of FSWerks intercooler dimensions?
I'm starting a DIY turbo and would like to know a good IC size for Focus.
22" x 5.5" x 2.5" will be fine? Turbo is a GT28, will run at 8psi and stock internals. It's a 2.0.

Thank you

1turbofocus 01-14-2013 10:33 AM

Those sizes will be ok , the big thing is the location to get clean air and to box the cooler good to make the air go through it , doing this you can get cooler air , make he IC more efficient , make safer power

Tom

Fernando_221 01-16-2013 11:25 AM

Quote:

Originally Posted by 1turbofocus (Post 4538724)
Those sizes will be ok , the big thing is the location to get clean air and to box the cooler good to make the air go through it , doing this you can get cooler air , make he IC more efficient , make safer power

Tom

Nice, I'll try to get it well located.

2.25" piping it's ok for turbo > IC > throttle body? I don't know what's the turbo engine outlet diameter, I think it's 2".

Turbo Turtle 01-17-2013 12:29 PM

turbo outlet size doesnt matter with intercooler piping. large piping will flow better but boost response will be slightly better with smaller piping. with a 28r i would either run full 2.5" ic piping with 3" maf housing or 2.5 hot side and 3" cold side

koke'sfocus 01-17-2013 03:37 PM

Yeah i m running like turbo turtle said 2.5 hot side 3" cold side with the fswerks ic the oulet and inlet r 2" but with my cfm tb (67mm) I don't have any issues with throttle response
Posted via FF Mobile


All times are GMT -5. The time now is 10:19 AM.


http://www.focusfanatics.com/aboutus/copyright.asp