Ford Focus Forum, Ford Focus ST Forum

Ford Focus Forum, Ford Focus ST Forum (http://www.focusfanatics.com/forum/index.php)
-   General Technical Chat (http://www.focusfanatics.com/forum/forumdisplay.php?f=47)
-   -   Front lower control arm bolt (http://www.focusfanatics.com/forum/showthread.php?t=302372)

nate4027 11-15-2012 07:06 PM

Front lower control arm bolt
 
Replacing the lower control arms on my car and can't believe how tight the bolt that goes through the sub frame is. Had a 1/2 drive breaker bar with 18mm impact socket and a 5 foot bar for leverage. The socket ended up slipping on the head of the bolt. Soaked it with PB blaster for two days prior. I am in the process of grinding the head off and driving it out that way. I am unable to heat it up due to the lack of room. Any suggestions before I start on the other side? Thanks

elsolo 11-15-2012 09:04 PM

Turn the nut, not the bolt.

xxMichaelAnthony 11-15-2012 10:20 PM

Quote:

Originally Posted by elsolo (Post 4457784)
Turn the nut, not the bolt.

This. When I did mine I assumed it was a welded on nut like everything else. Snapped the bolt and thought I was screwed. haha
And yes It is torqued on there pretty tight. Make sure you replace the bolts. They are torque to yield. I snapped the other one putting it back in and wasn't even close to the torque spec. Bolt part number - W706861-S439

nate4027 11-16-2012 10:09 AM

It looks like I will have to remove the sway bar to get room to get anything on the nut to turn it. Any other ideas?

xxMichaelAnthony 11-16-2012 12:50 PM

I left my sway bar on. You need to use an open end wrench to get at it. Socket wont fit.


All times are GMT -5. The time now is 07:40 PM.


http://www.focusfanatics.com/aboutus/copyright.asp