Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   General Technical Chat (http://www.focusfanatics.com/forum/forumdisplay.php?f=47)
-   -   Cylinder head temperature sensor wire fix. (http://www.focusfanatics.com/forum/showthread.php?t=302131)

gondorian 11-12-2012 07:43 PM

Cylinder head temperature sensor wire fix.
 
So I my car started throwing a code for the cylinder head temperature sensor (2.0 zetec) and also the temp gage stopped working. When I went to replace the cht sensor I found that the wire was broken.https://lh6.googleusercontent.com/-U...112_181542.jpg

What I found out is that you can remove the connector from the end of the cht sensor and take it apart, strip the wires, and reinsert them back into the connector. I was very glad this worked out because I the only replacement part I could find was the whole wiring harness. The only thing is that you need to be careful about taking the plug apart so you don't break the connection pieces. In the end I got it back together and it is working fine :)

https://lh3.googleusercontent.com/-q...112_185437.jpg

sailor 11-12-2012 08:41 PM

Good job!

You'll find that many special plugs can be repaired/reused, there is a special tool avail. to remove connectors from the type of plastic plug they clip into.

(difficult to describe, but a common type has a one piece plug that the connectors are pushed into until they click in place from the rear after being attached to the wire. pushing the right tool into the front of the plug unlocks them for repair/replacement)

Cheers for not giving up, and figuring out how to repair that connector!

gondorian 11-13-2012 07:18 AM

Thanks sailor! It's really a lot of fun to MacGyver a solution and spend $0.00.

amc49 11-14-2012 01:12 AM

Amen brother, I do stuff like that all the time.................they make fifty different types of plug, mostly to confuse, a good close look is the tool to figure out how it goes together. Dentist pick or hobby tool helps greatly getting in the small space there.

I just looked up several common Ford connectors to buy the metal only online for like 5 cents each, bought several sizes to be able to fix connectors without buying $15-$20 connectors as so many of them are nowadays. Just revamped coil connector on mine for like $2 of parts. Rebuilt radiator fan resistor and connector for maybe $3-$4, $60 part there and not counting connector.


All times are GMT -5. The time now is 04:31 AM.


http://www.focusfanatics.com/aboutus/copyright.asp