Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   MK1 Focus (http://www.focusfanatics.com/forum/forumdisplay.php?f=45)
-   -   ABS/Traction Control Light (http://www.focusfanatics.com/forum/showthread.php?t=301711)

Incognito27 11-07-2012 04:28 PM

ABS/Traction Control Light
 
So i was going to change my rear wheel bearings , but after thoughtful consideraton , i found it would be a whole lot easier to just buy a drum with wheel bearing already installed, makes my life easier. However i forgot one miner detail. The ABS "ring" i forgot to ask the guy whether these drums had them in them or not . Not that i would expect these particular guys to know. However i will ask here. For a 2003 focus ZX5 Would all of them have the "ring preinstalled or would i have to take the old ones off and install them on the new or do i just need to reset my ECM for the new bearings by unplugging the battery for 20 minutes.

I am hopeing i don't have the wrong drums with bearings cause taking the wheels off and taking it all apart is a pain in the you know what.

Thanks.

Mile30 11-07-2012 04:38 PM

Either or. I had the same issue on my '03. You can get the tone rings from Ford and carefully tap them on (I used a piece of wood and a dead-blow to ensure the ring went on flush). I've also heard you can remove the old ones and reuse them providing you don't ruin them in the process; but as tight as they are going on the former may be your best bet.

Incognito27 11-07-2012 04:40 PM

so bottom line is i need to get a set of tone rings and take apart my brakes again to get them on.
Wonderful :(

Thanks

Incognito27 11-07-2012 04:42 PM

http://www.autopartsottawa.ca/p-2929...ocus-2003.aspx

those are the drums i got ,


All times are GMT -5. The time now is 06:46 AM.


http://www.focusfanatics.com/aboutus/copyright.asp