Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   Focus Tuning Chat (http://www.focusfanatics.com/forum/forumdisplay.php?f=79)
-   -   Few questions (http://www.focusfanatics.com/forum/showthread.php?t=297086)

Indy'sexclusiveZx3 09-06-2012 07:34 PM

Few questions
 
Mods if not in the right spot please move, is there anything else that can cause the car to go into limp mode other then it getting ready to over heat, And what is p1127 and it's causes? And finally question with a datalog is there a way to find out if you PCM is shot?

1turbofocus 09-06-2012 09:05 PM

Exh temps out of range , o2 not complete , you could have a stopped up CAT , just guessing

Tom

iminhell 09-06-2012 09:14 PM

If you can datalog, you should also be able to look up the P1127 (in LiveLink, Ctrl+T).

Odds are it's a wiring issue with the O2 heater (rear O2).

Your ECU is just fine.
It's a tune issue more than it'd be a bad ECU.

1turbofocus 09-06-2012 11:10 PM

Quote:

Originally Posted by 1turbofocus (Post 4339449)
Exh temps out of range , o2 not complete

Tom

= p1127

iminhell 09-07-2012 12:05 AM

^I know what it is. Looked it up in my Ford software.
I was trying to show him how to find in with his software.

Indy'sexclusiveZx3 09-07-2012 12:10 AM

I don't have a cat, and I still need to finish my tune with Tom just be so damn busy

Indy'sexclusiveZx3 09-07-2012 06:22 PM

Ok more questions on top of the ones already, sometimes with in 2 mins of starting the car is will go into limp mode thoughts on fix? And Tom can you tune out the limp mode safety feature?????

1turbofocus 09-08-2012 10:42 AM

No that wouldnt be wise to do , but if you had a xcal we could narrow down your problem and fix it vs covering it up

Tom

Indy'sexclusiveZx3 09-09-2012 09:14 PM

Your right about not covering the problem up, but I just can't comprehend how it could go into limp mode after just idling for no more then two minuntes

iminhell 09-09-2012 10:25 PM

The MTF is wrong.
If you're tuning with Tom, get him datalogs of what he wants and I'm quite sure he'll get it working as it should.


All times are GMT -5. The time now is 09:01 PM.


http://www.focusfanatics.com/aboutus/copyright.asp