Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   General Forced Induction (http://www.focusfanatics.com/forum/forumdisplay.php?f=44)
-   -   rebuild options (http://www.focusfanatics.com/forum/showthread.php?t=293219)

burke_024 07-20-2012 01:45 AM

rebuild options
 
so i have forged pistons and rods and they are starting to slap i wanted to know what my rebuild options are can i reuse the setup with a differant block and new bearings or do i HAVE to get over sized pistons ,im just assuming its been honed once when the rods and pistons were done ,just a rough ballpark estimate and what i would need ,and the most realistic block to use ,thnx

1turbofocus 07-20-2012 07:39 AM

Thats hard to say , you need to remove the pistons and see what the sizes are , why are they slapping now ? did they collapse? you need to mic them at the skirt then at the top just below the rings , if the sizes are the same then check the bore size and see what piston clearances are

Why do you feel there is a piston size issue ?

Tom

burke_024 07-20-2012 01:16 PM

when i redid the head and gaskets the pistons move front to back in the bore like rocking on the wrist pin enough that at idle and lite cruise i can say that is the culprit of my slap,im just thinking its time for a rebuild never done one but ive never failed at anything ive tried so,im gonna do it ,anyone know of a good walkthrough let me know thnx

ZXthrizzle05 07-20-2012 07:14 PM

The rebuild is easy. But time consuming. Triple checking n labeling and torqueing and plastiguage

burke_024 07-20-2012 11:27 PM

thats what i figured im just looking for a good turbo build write up to follow

LiciouzSVT 07-20-2012 11:33 PM

^ that would be wonderful let me know if you find a good one I havn't been able to. Good luck with your build bro.

burke_024 07-20-2012 11:46 PM

will do hopefully someone can point us in the right direction

Magus2727 07-21-2012 09:35 AM

I used this build thread:

http://www.focusfanatics.com/forum/showthread.php?t=258140

to start my own rebuild:

http://www.focusfanatics.com/forum/showthread.php?t=289168

just watch out it can be time consuming and things can sneak up on you and you will find more and more things you will want to change out... at least I did. it was a well while I am at it I might as well do this... or replace that... or clean up this...

ZXthrizzle05 07-21-2012 03:04 PM

I rebuilt mine myself with the help of tom and rocco on the phone with me. You live in washington as well so it won't be a pain for me to help you

burke_024 07-22-2012 08:18 PM

yea cuz im gettin goil out of my breather on the valve cover at about 5 psi so im not driving it till it gets rebuilt ,my biggest question is if the crank and pistons are reusable i just wont kno till i get in there


All times are GMT -5. The time now is 12:26 AM.


http://www.focusfanatics.com/aboutus/copyright.asp