IROC turbo build continues
So I some of you guys know I purchased Roccos zx3 . It was a great deal and I'm very excited to say that I am the new owner. I will be heading to FSwerks tomorrow to begin tuning on the dyno.
This is what is done to the motor
Low Mileage Zetec Block. Bored/Honed with deck plate .007 over.
Stock Crank , oil holes chamfered, polished journals
Eagle connecting rods. JE 9.0 -1 pistons.
Comp cams stage II`s.
Ford racing headd
75mm Roush Racing throttle Body. Kenne Bell BAP . New SVT fuel Pump. And the 60lbs injectors.
ARP main and head studs. AEM cam gears.
Fidanza Flywheel, Competition Clutch stage 4 clutch.
Tial 50mm BOV and Tial 44mm WG.
New 2.5" hot side and 3" cold side to tb aluminum pipe.
Low mileage MTX with Torsen installed.
Things I have done already
Euro star LEDs
Red and black Svt interior swap
Svt coolant degas cover
Svt side mirrors that I vinyl wrapped
Svt black carpet kit swapped
Svt center console swapped
Svt speaker swapped
Things to do
Svt bumpers and side skirts/ paint /car have them
H&R coilovers already have them just need to install
Fswerks rear stress bar
Mach headlight install
New trans with hopefully a one off throw out bearing that won't break!
Swap slotted rotors
And roccos beast lives on
A one off throwoutbearing that wont break ? Did you break one ? Thats would be a first never seen any one break a throwout bearing in any of the Focus trans there would have to be something in the bellhousing to do this , what happen
tt b bck up that stattemnt yes rocco has broken it. he called me at the stop light he was sitting at when the first one broke. i even heard it thrrugh the phone!
You should paint your A pillar covers black so the gauge pod doesn't look so out of place.
i was thinking of doing that to my car as well but i kinda like having it black
So got to fswerks went to swap the plugs to find the headgasket is don't leaking coolant into the spark plugs ugh what a waste of time
was it at least a long drive?
I spoke too soon I think I have a leaky valve cover gasket we pulled the plugs dried up all the fluids and it looks like oil put new plugs back in the car things running like a beast time to go on the dyno
|All times are GMT -5. The time now is 01:17 PM.|