Ford Focus Forum, Ford Focus ST Forum

Ford Focus Forum, Ford Focus ST Forum (http://www.focusfanatics.com/forum/index.php)
-   Focus Tuning Chat (http://www.focusfanatics.com/forum/forumdisplay.php?f=79)
-   -   Faulty code (http://www.focusfanatics.com/forum/showthread.php?t=253090)

dennistheii 03-14-2011 08:23 PM

Faulty code
 
I'm getting this code p0135 o2 heater circuit bank 1 sensor 1. So I put a new front o2. But code keeps coming on. What do I need to do. Did i misunderstood the code. The sensor 2 has same faulty code but getting toms tune this week and it turns off rear o2 so not to worried about that but help with the other one would be great. Thanks

BC_ZX3 03-14-2011 10:52 PM

Check your wiring harness and connectors.

P0135 - HO2S Sensor Circuit Malfunction (HO2S-11)
During testing the HO2S Heaters are checked for opens/shorts and excessive current draw. The test fails when current draw exceeds a calibrated limit and/or an open or short is detected.
Short to VPWR in harness or HO2S.
Water in harness connector.
Open VPWR circuit.
Open GND circuit.
Low battery voltage.
Corrosion or poor mating terminals and wiring
Damaged HO2S heater.
Damaged PCM.

1turbofocus 03-15-2011 09:47 AM

If your getting my tune just hang on till you get it and with the predator we will be able to datalo and get the problem fixed

Could be
o2 fuse
wiring
to check these 2 with key on unplug the o2 sensor and with a test light see if you have power to the o2 sensor

could be that your running lean , tune and datalog will tell us that , check good for Vac leaks , dirty MAF

Tom

dennistheii 03-20-2011 08:38 PM

Ok only getting p0135 sensor 1 bank 1 heater circuit code now after tune. No vacuum leak fixed that. How do I data log with the tuner?

1turbofocus 03-21-2011 08:24 AM

Check to see what the voltage is with the key on engine not running at the front o2 sensor , unplug it and see what the voltage is , if you have no voltage check the fuese on the fire wall then check the wiring

If you have voltage then datalog and send it to me datalogging is under diagnostics

Tom

dennistheii 03-21-2011 04:55 PM

Ok got it fixed turns out to be a fuse. Question one last code left. It doesn't set off check engine but still. P1000, obd systems readiness test not complete. What is that. Should i be concerned?


All times are GMT -5. The time now is 09:59 AM.


http://www.focusfanatics.com/aboutus/copyright.asp