Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   SVT Interior Mods & Upgrades (http://www.focusfanatics.com/forum/forumdisplay.php?f=110)
-   -   looked everywhere, cant seem to find out the answer... (http://www.focusfanatics.com/forum/showthread.php?t=228090)

desponge 04-01-2010 01:15 PM

looked everywhere, cant seem to find out the answer...
 
i just gutted my interior on my zx3. im replacin everything with the svt interior, got the carpet in and just realize that the lower rear seats have four bolts that hold them in and the zx3 has two because the zx3 seat is all one seat. not two pieces lke the svt. what do i have to do to get the seats to mount up, i can post pics if you cant understand what i mean

Focus'd 04-01-2010 02:02 PM

I'm actually about to do the swap as well, this would help alot if I knew what to do before I start gutting.

RSVT170 04-01-2010 09:03 PM

I have done this swap. Pesonally, I just never bolted in the two center brackets, and it works fine. If you really want them to be bolted in, you could use wither some large self tapping screws (Be sure to use some rubber washers) or drill the holes, then tack weld nuts into place from under the car on the back side then use a regular bolt to secure them in.

goinloco1 04-01-2010 11:07 PM

DO NOT do the above without first checking whats behind where your going to drill. there's all sorts of lines and stuff back there, make sure the area is clear. :)

Alex Arce 04-01-2010 11:19 PM

thats wierd my zx3 had all the holes needed for the svt seats to bolt up with no problem. im just assuming since both of your cars are both pre SVT you dont have the proper holes already drilled. but i agree with RSVT170 just dont bolt them up

Focus'd 04-02-2010 01:11 AM

So we should just bolt them in and forget about the centers or drill some in but first check where we're drilling.

tkheaven 04-02-2010 01:05 PM

Sounds about right..not that I've ever owned an SVT or plan on doing this sort of gutting.. but it makes sense... :)

slipster17 04-02-2010 03:35 PM

I did the SVT interior swap on my ZX3 (2001) and never bothered with figuring out the center two bolts. Seats hold fine without them (going on 3 years with this interior)

desponge 04-03-2010 12:19 AM

thanks guys, i just bolted them up i culd wait to get them in before i heard anyones post lol, i had to put i small piece of carpet foam under the driveside rear seat in order for in to sit right because i didnt bolt the otherside up. i am probably goin to selftap them tomorrow

norcalfocus01 04-03-2010 12:24 AM

Just be real careful the gas tank is plastic and right under the rear passenger seat. A self tapping screw could easily go right into the tank.


All times are GMT -5. The time now is 11:10 PM.


http://www.focusfanatics.com/aboutus/copyright.asp