Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum

Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum (http://www.focusfanatics.com/forum/index.php)
-   Drag Racing (http://www.focusfanatics.com/forum/forumdisplay.php?f=96)
-   -   best shift points? (http://www.focusfanatics.com/forum/showthread.php?t=212044)

1sicfuc 09-24-2009 07:20 PM

best shift points?
 
so i have 4-2-1 headers, 2 1/2 piping, intake running through headlight, steeda wires, and thats about it what rpm should i shift at to get my best 1/4 mile?? my car goes all the way to 6,950 rpm before rev limiter but i know stock focus power band drops off after like 5,500 or something, when should i shift??[confused]

mlbbaseball 09-24-2009 08:31 PM

you should shift around 6500 - 6700. the stock cams run out of power at about 6500 or so.

1sicfuc 09-24-2009 08:55 PM

Shifting pointers in manual
 
So i usually shift at 6,950 right before rev limiter but dont know if its making me slower or faster doing that.?? Should I be shifting at like 6,000? my car has 4-2-1 race headers, 2 1/2 piping with n1 muffler, cold air intake, good plugs, and steeda wires, and my car wieght is under 1,600 lbs after everything i have taken out and off of it. I know that the stock 2.0 powerband dies after like 5,600 or so but what about mine??[vommit]

1sicfuc 09-24-2009 09:08 PM

sweet, thanks. i have shifted at like 5,500 and 6,000 and it seemed way slower to me, but 6,500 sounds right.

SVTflyer03 09-24-2009 09:16 PM

I always take mine to JUST before the limiter. If you shift too early then when you go into 2nd or what-have-you, you will be at an even lower RPM.

Example:

If you shift at 7k for instance, then when you go into second you will be around lets say 4,000 - 4,500 RPM, hence you will be in a better power range if you were to shift earlier.

Like...

If you shift at 6k then when you go into 2nd, then you will be at like 3,000-3,500 RPM, meaning you will be in a lesse power band, meaning it will take longer to get up to speed.

I say shift as high as you can without hitting the limiter, that way you will be in the "sweet spot" of power.

Thats what I believe anyways.

1sicfuc 09-24-2009 09:46 PM

thanks, i will keep doin what ive been doin then. I cant wait till i can bring the rpms even higher, like 8,000!!

SVTflyer03 09-24-2009 09:50 PM

Getting cams and a tune are we???

1sicfuc 09-24-2009 11:21 PM

you bet i am!!! this winter its my next upgrades..

2wheeladict 09-25-2009 02:35 AM

theres a difference in engine redline and usable redline. engine redline is when your engine can no longer flow more air. usable redline is where your power starts dropping off. the rule of thumb is about 500rpm after usable redline is your shift point. so find a dyno sheet for your setup and look at the rpm right at peak hp, then 500 after that.

1sicfuc 09-25-2009 02:44 AM

good lookin out, will do.


All times are GMT -5. The time now is 09:59 PM.