Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum

Ford Focus Forum, Ford Focus ST Forum, Ford Focus RS Forum (http://www.focusfanatics.com/forum/index.php)
-   General Technical Chat (http://www.focusfanatics.com/forum/forumdisplay.php?f=47)
-   -   Code P1246 (http://www.focusfanatics.com/forum/showthread.php?t=189468)

Slow03 02-23-2009 04:52 PM

Code P1246
 
Hye guys,

I have had the P1246 code showing up in my Predator. It has not caused a CEL but ever since I have been getting this code I have noticed a new symptom. The code reads IIRC Alternator Load Input.

Now sometimes when I stop at a light or sit at idle the car sometimes will start to sputter. The idle will fluctuate a little. It does the same thing to when I turn the heat on. If I turn it off, the idle will go back to normal.

Now what I am trying to figure out is, does the P1246 code only mean that the Alternator is going out? I tried searching the code but not a lot came up. If the Alt. is going out, would that cause the syptoms I list?

Let me know guys.

Thanks

iminhell 02-23-2009 05:05 PM

Quote:

P1246 - Generator Load Input Failed (All Others) The PCM monitors generator load from the generator/regulator in the form of frequency. The frequency range is determined by the temperature of the voltage regulator where 97% represents full load, below 6% means no load. Generator circuit short to GND
Generator circuit short to PWR
Generator circuit open
Generator drive mechanism
Damaged generator/regulator assembly
Damaged PCM
Verify battery voltage is 14.5V.
Verify generator/regulator has the correct part number.

To me that sounds like 1 of a couple possibilities.

A. You have underdrives are are not tuned for them. Though I don't think that really happens, possible though I'd think.
B. The alternator is not making a good ground to the block. Corrosion or maybe a lackluster engine ground.
C. The "alternator clip" has failed or is failing. --> http://www.focusfanatics.com/forum/showthread.php?t=104396


C. would be my best guess as it makes the most sense to me.

Slow03 02-23-2009 05:42 PM

Well we can take #1 off cause I do not have any UDP's. Thanks for that info. I will look into those possibilities. I really hope the Alt. itself is not going bad cause I do not want to buy a new one or have to go through putting it on.

malim 02-23-2009 07:10 PM

Same problem bud. Your lights dim as well when you turn on or off the heater? (interior - dome light)

Slow03 02-23-2009 10:20 PM

I have not paid attention to lights. I just freak out becuase it idles all wierd and stalls on me. Or at least it stalled on me today while the idle was going crazy. I will give that a look tomorrow.

Slow03 02-24-2009 06:39 PM

Well I checked the alt. clip. All the wires are intact. Could the clip still be bad?

I have not checked the ground yet. The wierd idiling that happens when I stop is driving me crazy.

Chewman 04-10-2009 03:51 PM

you still having this problem, I am having some of your symptoms as well.

boarder 04-04-2010 06:25 PM

double post

boarder 04-04-2010 06:26 PM

Im having this problem right now, either of you fix the problem?

SVTRSST 11-01-2011 04:01 PM

bump! this might be the cause of my hanging rpm


All times are GMT -5. The time now is 10:45 AM.