Focus Fanatics

Focus Fanatics (http://www.focusfanatics.com/forum/index.php)
-   ZETEC Performance (2000-2004) (http://www.focusfanatics.com/forum/forumdisplay.php?f=39)
-   -   Weld in roll cage (http://www.focusfanatics.com/forum/showthread.php?t=165953)

mlbbaseball 07-09-2008 08:34 PM

Weld in roll cage
 
I was originally looking for a bolt in roll cage but now I am wanting a weld in because they are better. The only one I have found so far is S&W Race Cars, they don't have a cage already made, I have to custom measure it. so I have 2 questions, has anyone got a weld in? if so, where did u get it from and did u have to measure it? Or does anyone in general know of a good place besides autopower roll cages? thanks

mlbbaseball

SuperFocusMan 07-09-2008 09:21 PM

If you are going to do it the proper way, then you want DOM tubing (Drawn over mandrel) which usually runs about 4 to 7 dollars a foot.


http://www.metalsdepot.com/products/hrsteel2.phtml?page=rndtube&LimAcc=$LimAcc

Length is going to vary depending on what type of cage you plan on putting it

mlbbaseball 07-09-2008 09:34 PM

Ya, i know about DOM, it is what SPEC racing requires, thats why I was already planning to go w/ it!!


All times are GMT -5. The time now is 03:35 AM.


http://www.focusfanatics.com/aboutus/copyright.asp