Ford Focus Forum, Ford Focus ST Forum

Ford Focus Forum, Ford Focus ST Forum (http://www.focusfanatics.com/forum/index.php)
-   General Technical Chat (http://www.focusfanatics.com/forum/forumdisplay.php?f=47)
-   -   2002 FOCUS CODE P0750 Shift Solenoid A Malfunction (http://www.focusfanatics.com/forum/showthread.php?t=130931)

regis 08-08-2007 08:04 PM

2002 FOCUS CODE P0750 Shift Solenoid A Malfunction
 
Hi I'm having problems with the transmission after third shift it jumps into neutral for like five seconds then jumps hard into fourth, I purchased a OBDll CAN scaner and it read P0750 Shift Solenoid A Malfunction I cleared the code and the car ran perfect for like two days and started all over with the same code, how hard is it to replace this solenoid and witch one is it in the transmission box and do you think this will take care the problem, I went to the ford dealer and one solenoid cost $100 not bad but it shows 3 in the transmission witch one is it?, I know if I take it to a transmission shop they just want to replace the transmission to make more money, I'm a aircraft mechanic and I think I can do this but I need more information from someone thats been thru this problem before, thank you in advance for your help.

UPDATE 8/9/2007: Now the code won't clear & the engine light resets off and comes back up within 2 minutes (It's getting worst HELP)

tekilazo 08-08-2007 09:05 PM

I have the same problem, let me know if you figure it out.
http://www.focusfanatics.com/forum/showthread.php?t=130821

FociBoi121 10-15-2008 04:57 PM

http://www.focusfanatics.com/forum/s...ighlight=p0750

has the how to very easy to replace

danskool 10-15-2008 07:44 PM

My problem has a bit different symptoms. Mine don't toss on the light.
http://www.focusfanatics.com/forum/showthread.php?t=176193


Your Light and Malfunction A.
5/16 socket 1/4"drive and a 2"extension. Is all you need.
An oil catch pan/Filter and 4 quarts of oil. and some rags.

Pull pan. 20 screws. SPLASH
Unplug temp sensor from filter. Plug sensor in new filter. (just pulls out)
Pull Down filter. Has oring squeeze is all. She comes out with a tug.
Unplug "a"
5/16 on solenoid.
Tug on solenoid. She slides out.
Oil up orings on new solenoid and pop back in.
Plug wire back in.
install filter
reinstall pan with gasket that came with filter.
Torque bolts to 60-70 inch pounds.
Dump in 3 quarts.
Check and add if necessary.


Shift solenoid A: P/N XS4Z-7H148-AA $45.77 same as A,B Just bought one two days ago.
http://i233.photobucket.com/albums/e...l/solenoid.jpg

Dan

FociBoi121 10-15-2008 08:31 PM

you mean trans fluid right no oil?

moenterzx3 10-15-2008 08:37 PM

he may have gotten this fixed already. it was about a year ago

FociBoi121 10-15-2008 09:39 PM

Quote:

Originally Posted by moenterzx3 (Post 2395057)
he may have gotten this fixed already. it was about a year ago

i kno well im going through the same problem and doubt hes an active member anymore so i thought id go through a couple posts and place the how to i found
i donno bored and frustrted i guess

foxyl6162 04-07-2011 07:22 PM

Dandcool tyvm for the informative diagram made things insanely easy lost O.D and thought trans would be done Thanks was solenoid A works fine after replacing it, so far drove 20m ill see how it is in a week and then celebrate hehe.

Gilbey725 11-11-2011 11:45 AM

Solenoid A
 
Thank you to everyone for the great information. My OBD reader was saying Solenoid A. Followed the other posters instructions and have no problems again. Most of the shops wanted 2 hours labour. I did it in about 2 hours myself. My 02 Focus has 261k kms. Still going strong. Also did the Thermostat Housing recently.

Davelavallee 03-21-2012 05:17 PM

Old thread or not it just saved me a lot of money


All times are GMT -5. The time now is 02:22 PM.


http://www.focusfanatics.com/aboutus/copyright.asp