Ford Focus Forum, Ford Focus ST Forum

Ford Focus Forum, Ford Focus ST Forum (http://www.focusfanatics.com/forum/index.php)
-   General Forced Induction (http://www.focusfanatics.com/forum/forumdisplay.php?f=44)
-   -   Supercharged SVTF Quarter Mile Times (http://www.focusfanatics.com/forum/showthread.php?t=10319)

TooGQSVT 03-30-2004 03:59 PM

Supercharged SVTF Quarter Mile Times
 
Hey guys. I was just wondering if anybody has a supercharger on their SVTF (Vortech or Jackson) and what they run in the quarter mile. I wanna be able to ride with STi's and Evo's and thats pretty much the only way an SVTF will do it....unless you wanna spend about $7k on Tom's kit. No thanks.

ZETEC3 03-30-2004 04:21 PM

Hate to break it to ya but even with a Vortech youll end up having to spend more than what toms kit cost to be able to hang with STI's and EVO's. With the vortech kit there is a slim chance that youll run with a stock EVO from a roll. And with either from a stop your dead. Its hard to match either of these cars without going turbo. And with the SVT's high compression youll need a new set of pistons if you wanna be making the kind of power to be right up there with an EVO or STI.

Infra3sv 03-30-2004 04:54 PM

I could see it. A vortech with a pulley and some bolt-ons could be Lancer territory. Focus CFM says the Vortech is good for 276 hp and 204 ft/lbs.
Evolution weighs some 3,250 pounds. 11.75 lbs/hp & 11.75 pounds per ft/lb of torque
Focus 2,770 pounds.______________10.04 lbs/hp & 13.59 lbs/ft/lb or torque
The Lancer will always take the Focus off the line but I think the Vortech could be the answer. Oh yeah, you'll need a lot more power than this in the quarter to hang with those badass cars because AWD oWn3s FWD in stoplight racing.

tjm73 03-30-2004 04:55 PM

Speaking of pistons...............who makes them for the Focus?

R&DSVTZX5 03-30-2004 05:10 PM

As I know there are no aftermarket pistons yet for the SVTF.

tjm73 03-30-2004 06:14 PM

Quote:

Originally posted by R&DSVTZX5
As I know there are no aftermarket pistons yet for the SVTF.
What about regular? Eagle is making H-Beam rods.

Dave 03-30-2004 07:04 PM

I saw a stock srt-4 run side by side with a evo from a roll, just when they ran from a stop the evo whooped him. With a vortech and some slicks you should be able to take out a evo pretty easily. More hp, less weight, and cut like a 1.9 60' time.

mofocus 03-30-2004 07:08 PM

well when you get up into the big #s slicks=broke axles

Dave 03-30-2004 08:30 PM

Quote:

Originally posted by mofocus
well when you get up into the big #s slicks=broke axles
I wasn't talking big numbers, just like 250-260 whp.

sexy2002svt 03-30-2004 09:03 PM

so, basically, noone has a time? (the original question)


All times are GMT -5. The time now is 09:47 AM.


http://www.focusfanatics.com/aboutus/copyright.asp